Quill Vogue Wash Station Static/XL

Quill Vogue Wash Station Static/XL

Quiet, Fast Support Removal for Stratasys PolyJet Parts

The Quill Vogue Wash Station Static uses pressurised cold water to quickly and quietly remove support material from Stratasys Polyjet 3D printed parts.

The high-performance Wash Station rapidly removes a range of support material from complex geometries and deep recessed areas without damaging surfaces.

The Quill Vogue Wash Station Static is an “open” system that requires plumbing into mains water and mains drains and thereafter requires very little maintenance.

 

Technical Specifications

Wash Station Static

  • Footprint: 640mm x 610 x 1520
  • Internal Chamber: 320mm x 520 x 530
  • Weight: 67kg
  • Power Supply: UK – 240volt AC/50Hz/1.6kW single
  •  phase/13amp

Site Requirements:

Quill Vogue Wash Station Static is an “open” system that requires plumbing into mains water and mains drains and thereafter requires very little maintenance.

  • Mains fed water flow rate: 12 to 30 litres per minute. Copper pipe (15mm) with washing machine isolating tap is recommended.
  • Drainage: Drain to foul sewer. Drainage must be gravity fed (use a washing machine U bend) and must not go above the height of the Wash Station. Operators must ensure they comply with local government discharge guidelines.

 

Wash Station Static XL

  • Footprint: 1070mm x 740 x 1650
  • Internal Chamber: 670mm x 660 x 510
  • Weight: 118kg
  • Power Supply: UK – 240volt AC/50Hz/1.6kW single

Site Requirements:

Mains fed water flow rate: 12 to 30 litres per minute. Copper pipe (15mm) with washing machine isolating tap is recommended.